Wednesday 16 January 2008

Art Clay Silver Tech Heart Pendant


Roll out a thick sheet of metal clay (approximately 3/8" thick).

Press a computer circuit board onto the clay to make a texture. Use ACS Pure Balm to prevent the clay from sticking to the board.

Use a small circle cutter to cut out a circle for the middle of the heart. Use a heart shaped cutter to cut the outside shape with the cut circle centered in the middle.

Slide a head pin vertically up through the bottom of the heart and out through the top. Twist the head pin to widen the hole a bit. Remove the head pin.

Let the heart dry.

Lightly sand the edges with a Glass file, Sanding Blocks or Sanding Pads

Fire the heart at 800°C for 5 minutes in kiln, 5 minutes on a Gas Hob or 2 minutes with a Gas Torch.

After firing, burnish the piece with a brass brush. Follow with a burnishing tool to polish the edges and the high spots for a brighter shine.

Thread the head pin up through the heart. Use a needle to widen the hole if necessary. This will compress and burnish the hole. Place a bead in the center of the heart and thread the head pin through the bead and up through the top of the heart. Use pliers to make a loop for hanging. Twist the wire a few times and clip off the excess wire.

Hang the heart from a chain.


All that you need to create this unique Pendant is available Here..

For more information on using, drying and firing Art Clay please take a look the Resources Page